Smog Check and Auto Repair of Irvine, CA is a complete low cost auto repair station and is a state licensed Smog Check Station. Our technicians are Automotive Service Excellence Certified ( ASE Certified ). We provide service on all cars and trucks – domestic cars and foreign cars. Our station does complete auto electrical work and complete auto troubleshooting. Auto Check Center – Smog Check and Auto Repair is state certified for Brake and Lamp Certification for Salvaged Vehicles and is licensed to perform these inspections. Registering for vehicles in the State of California with a Salvaged Title DMV requires a Brake and Lamp Inspection Certification in order for the owner to obtain title – we can help you get your title.
How to pass Smog Test
October 2, 2011 by
Every two years, California vehicle owners face having to submit their car to smog test. To prepare for the test, Smog Check Irvine recommends five things that can make the difference between passing and failing the test.
Step 1 – Change the Oil and Oil, Air, and Gas Filters
Dirty oil causes bad emissions to come through on the test. In addition to changing the oil, be sure to change the oil filter. Change the air filter for optimal results. If the fuel filter is over five years old, it also needs to be changed.
Step 2 – Check the Positive Crankcase Valve (PVC)
Give the PVC a shake. If it clicks, then it is working fine. If not, it needs to be changed.
Step 3 – Change the Spark Plugs
If the spark plugs appear dirty or worn, they probably need to be changed. When checking the spark plugs, don’t forget to check the wires as well. If they are looking worn, they might also need to be replaced.
Step 4 – Check for Leaks
Check all of the hoses in your engine compartment, especially vacuum lines. If there are any that show wear, replace them. Look for oil leaks. If there is oil on the engine, it means the vehicle is losing oil pressure and emissions are going to be off. Many times oil leaks result from failed gaskets, which must be replaced.
Check for exhaust leaks. To do this, simply start the vehicle and rev up the engine. If the muffler sounds unusually loud, then there is probably an exhaust leak that needs to be fixed.
Step 5 – Bring the Vehicle in Warm
One final thing you can do the day of the test is to drive the car fifteen minutes on the freeway, and then fifteen minutes on the city streets before bringing it in for the test.
